Title: Metric/imperial parameter#115 [Print This Page] Author: ianj Time: 2021-4-25 03:02 Title: Metric/imperial parameter#115 Last edited by ianj In 2021-4-25 03:32 Editor
Hello. I've just purchased DDCS4 V3.1 with ver 2020-03-06-112NOR firmware loaded. I bought this because "the new features " state the unit is compatible with metric and imperial units.In the user manual v3 page 72 parameter #115 0=mm and 1=inch, but when I go to parameters on the unit #115 does not appear in the list.Author: ShaniaDDream Time: 2021-4-26 11:41
You need to press " page R“ to store the setting and then reboot the controller, after that you can use the imperial units .Author: ianj Time: 2021-4-26 20:55 Last edited by ianj In 2021-4-26 22:40 Editor
Hello Shania.
Thank you for your reply. My problem is I cannot find #115 on my controller.The manual shows 12 system setting parameters including #115. On my controller in system settings there are 13 items including #120 & #2039 which are not mentioned in the manual but NO #115.
Is #115 in system settings on your controller?
Thank You.Author: ShaniaDDream Time: 2021-4-27 08:40
Mine is also ver 2020-03-06-112NOR. You find them in the wrong place, when you press "Page R", the first column is -----【Top parameters] listed as below, and the fourth line , that 's it.
5. minimum radius of 4 axis machine
6. A axis rotate reference axis
104. A axis optimal path when GO run
115 Unit selection mm----- here is it
I know what you are talking about, you are going to the column under it. The column name is -----【system settings】， it has 13 items including the new features #120 and #2039 that are not listed in our manual, because the manual has been updated yet.
You can try it again, hope it helps.Author: ianj Time: 2021-4-27 15:31
Hello Shania.
Thank you very much for your answer. Problem now solved.
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)