Title: DM800 Garbage? [Print This Page] Author: cburd Time: 2021-4-18 08:04 Title: DM800 Garbage? Last edited by cburd In 2021-4-18 08:05 Editor
A while back, I had an issue with the spindle control, Jessy sent me a file that totally screwed everything up. After pleading, cajoling and nagging, he finally sent me another file that looked promising but again, did not work. Now I have a DM800 that DOES NOT work, and no income (because the controller doesn't work). Does anyone have a FACTORY original file that they can send to get this damn thing working? Otherwise I am out months of my time, several jobs that I couldn't do and the cost of a defective piece of equipment.
NOT IMPRESSED!Author: milawka2222 Time: 2021-5-2 17:13
Take the youngest firmware from this forum, and install it, I don't understand what the problem is with installing the firmware, and the device is configured for each machine individually and independently of non-non-viral firmware, read the instructions !!!!!
If there is a lack of brain, then you should not poke your nose where the brain will no longer help !!!!!!!!
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)