Title: Reverse run feature request [Print This Page] Author: Caxec Time: 2021-4-9 23:45 Title: Reverse run feature request Last edited by Caxec In 2021-4-10 01:14 Editor
Hello!
We are using DDCSV3.1 in sewing machine. Sometimes thread breaks, so we need to stop the program and go back to the place where thread was broken and then start the program from that point. We tried to use handwheel guide (Try Cutting), it can't run program in reverse, only forward.
So we need to stay with Mach3 at the moment. Is it possible to add such feature?
Author: ShaniaDDream Time: 2021-4-13 11:15
Yes, the handwheel guide only can go forward; cannot go back. Sorry. DDCS V3.1 is just like this.
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)