Title: Help with wiring [Print This Page] Author: GotDiesel Time: 2021-1-26 11:26 Title: Help with wiring Router 6060 Wentai manufacturer. I installed 3.1 DDCS. I can operate 3 axis and turn spindle on with screen. Remote hand control estop button is depressed. If I release button, alarm goes off. Why does screen work if button is depressed? What am I doing wrong and why is the alarm? Also, there is a terminal block for connections of a estop on machine, but I am not clear on the wiring. It looks like you need a switch that grounds all the 3 terminals? Can you send me a link to a proper switch and how to wire it? Author: GotDiesel Time: 2021-1-26 11:34
Also, when I just press x or y arrow keys, axis seem to move too fast and hard. How do I slow down that action?Author: GotDiesel Time: 2021-1-26 22:50
Does the manufacturer not visit this forum? Author: Ubdstu Time: 2021-2-14 02:51
Check parameter # 429 Electric level of ESTOP on MPG - change it from 0 to 1 or 1 to 0. Should fix your ESTOP.Author: Ubdstu Time: 2021-2-14 02:52
Check parameter # 429 Electric level of ESTOP on MPG - change it from 0 to 1 or 1 to 0. Should fix your ESTOP.Author: Ubdstu Time: 2021-2-14 02:55
Change parameter #100 and #101 to lower values.Author: GotDiesel Time: 2021-2-16 08:28
I fixed Estop with that, however the wheel still does not work. No axis moves. If I try to move any axis with MPG, I can hear X motor make noise, but not move. Author: ShaniaDDream Time: 2021-3-15 13:39
Please check our manual on Page 8, you can find a star/Pause/ E-stop switch connection port there. Then you can connect your E-stop switch 's one end to its "E-stop" pin and another one to its"COM" pin, hope it helps.
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)