Title: Dual motor on Y axis (slave axis) [Print This Page] Author: joelam Time: 2021-1-11 18:13 Title: Dual motor on Y axis (slave axis) Hello,
We are looking for an offline motion controller that have a full support of dual motors on Y axis.- different step/dir channel and separate home switch for auto-squaring the gantry
(The two motors operate in synchronization when cutting. But when resetting the machine or homing: they are adjusted independently, on their respective limit switches).
Do your DM500 controllers support this function ?
Cordially
Joe Author: milawka2222 Time: 2021-2-28 09:22
No, not supported. For a long time, special attachments have been developed for this for synchronizing and aligning engines.Author: Juzer99 Time: 2021-3-23 03:53
Where the Sen Sync V1.3S board can be purchased?
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)