Title: ddcs v3.1 lose steps [Print This Page] Author: danielrodrigues Time: 2024-5-14 11:01 Title: ddcs v3.1 lose steps my ddcs was working normally on my router. It had already been installed for 1 year. Yesterday I noticed that the x axis that has an easy servo started to lose steps, it returns away from the zero point. I already checked the wiring and tested it on 2 other different motors and drivers. the problem persists. Can ddcs create this problem of missing steps only on the x axis?
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)