Digital Dream Technology support

Title: DDCSV2.1 Laser parameter [Print This Page]

Author: Miklo Time: 2024-5-12 02:10
Title: DDCSV2.1 Laser parameter
Last edited by Miklo In 2024-5-26 15:03 Editor

HiI installed a laser on my CNC.

It is connected to the VSO and GND pins of my DDCSV2.1.

Unfortunately, it stays on all the time while burning.

What are the settings in "Spindle parameter" in the DDcs so that the laser turns on and off depending on the Gcode?

Or if you also installed a laser, what are your settings in "Spindle parameter"?

Thank you so much for your help.

(Sorry for the translate)

Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)