Digital Dream Technology support

Title: Solid state relay connection issue [Print This Page]

Author: riaan Time: 2024-3-7 19:53
Title: Solid state relay connection issue

Hi All. I am trying to connect a solid state relay to my ddcs v3.1 touse on my M3/M5 command.

My + trigger wire is on the M3 port and - is on the -COM port on theback of the ddcs.

The problem I am having is the trigger voltage is to low.

I did test that the solid state relay works by putting 5V battery on itand connecting a 220V bed lamp to the other side.

When I trigger the M3 command I can se a voltage difference from 0V to+- 2-3V.

I believe from reading the Manuel the output voltage on the trigger shouldbe 10V.

Any help on this would help.

Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)