Digital Dream Technology support

Title: Ddcsv 3.1 will not fun g code file [Print This Page]

Author: Sparfab Time: 2024-3-4 01:46
Title: Ddcsv 3.1 will not fun g code file
I just purchased a ddcsv3.1 from Amazon, it had some glitches so I upgraded the firmware to the latest version Now, when I try to run a g code file,
The Z axis barely moves. Then the beeper goes off and that's all it will do need a fix

Author: marco@SAVI Time: 2024-4-23 00:16
SALVE HO ANCHE IO LO STESSO PROBLEMA COME LO AI RISOLTO POTRESTI DIRMELO GRAZIE

Author: Idalid Time: 2024-6-14 23:43
Hi, i have the same problem, could you tell me how do you fix it? please

Author: Idalid Time: 2024-6-14 23:43
Hi, i have the same problem, could you tell me how do you fix it? please, thank you and have a nice day

Author: Idalid Time: 2024-6-14 23:44
Hi, i have the same problem, could you tell me how do you fix it? please, thank you and have a nice day

Author: Idalid Time: 2024-6-14 23:46
Hi, i have the same problem, could you tell me how do you fix it? please, thank you and have a nice day

Author: Angel17 Time: 2024-6-20 21:39
Is that resolved now? Keep us updated! water heater installation denver

Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)