Title: M3 / M5 PROBLEM [Print This Page] Author: elisadia Time: 2020-11-26 19:57 Title: M3 / M5 PROBLEM Hello friends!
I use a DDSCV2.1 plasma cutting controller. Uses SHEETCAM software.
When I try to play a file, the torch (M / 3) immediately starts working. At the end sometimes M / 5 turns off the torch and sometimes it does not depend on the POSTPROCESSOR I chose. In the SHEETCAM simulation it works great. Shows that the torch is off and when it reaches the object it lights up.
What's wrong?
Thanks so much for the help.
ELIKO
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)