Digital Dream Technology support

Title: Датчики [Print This Page]

Author: Frost Time: 2020-11-8 22:18
Title: Датчики
Last edited by Frost In 2020-11-8 22:20 Editor

Поддерживает лиCNC Motion Controller DDCS V3.1 датчики PNP NC, как их подключить

Author: JessyChen Time: 2020-11-17 21:05
DDCS V3.1 не поддерживает PNP, поддерживает только тип NPN.
DDCS V3.1 don't support PNP, only support NPN type.

Author: DZiK Time: 2020-12-4 05:13
I'll take a look tomorrow.
The panel supports my positive probe and a negative Z height sensor in one slot without switching settings.
The panel is galvanically isolated, you can just try if it works or not.

In the panel settings, there is definitely a switch from a low signal to a high one.

Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)