Title: z axis keeps jogging after jog button is released [Print This Page] Author: mxpro32 Time: 2020-10-29 03:25 Title: z axis keeps jogging after jog button is released Hi. if I hold the z axis jog button down and then let go, it keeps moving for a bit. sometimes its an inch other times a few inches and it crashes into the end of the travel. the x and y axis don't do this. here is a video https://www.dropbox.com/s/s1mb1y ... _233902154.mp4?dl=0 Author: mxpro32 Time: 2020-10-30 04:11
did you see the video I linked to? its not moving very fast. it jogs at a steady pace for a while after you let go of the button, then it decelerates to a stop. its a different distance each time. Author: mxpro32 Time: 2020-11-3 07:19
thanks for the replies. I figured it out. there is a setting for max z axis jog speed, then there is a setting for low speed jog and high speed jog. the max jog speed was lower than the other jog speed settings so it was acting funny. I increased the max jog speed setting and it fixed it.
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)