Item | European-spec Double Girder Gantry Crane | |||||
Lifting capacity | t | 15 | ||||
Lifting height | m | 7 | ||||
Span | 20 | |||||
Speed | Cross traveling speed | m/min | 2.0~20 (inverter control) | |||
Crane traveling speed | 2.0~20 (inverter control) | |||||
Lifting speed | 0.7~4.0 (inverter control) | |||||
Working class | / | FEM2M (ISO M5) | ||||
Power supply | V/Hz/P | 415V/50HZ/3P | ||||
Crane traveling power | KW | 2.2*2 | ||||
Trolley traveling power | 1.1*2 | |||||
Lifting power | 13 | |||||
Total power | 19.6 | |||||
Max. wheel load | KN | 141.2 | ||||
Total weight | t | 20.9 | ||||
Ambient temperature | / | -20℃ ~ +40℃ | ||||
Anti-collision system | / | Included | ||||
Phase protection relays | / | Included | ||||
Limit switch | / | Included | ||||
Voltage Low Protect device | / | Included | ||||
Emergency stop action | / | Included | ||||
Ground fault protection | / | Included | ||||
Short-circuit protection | / | Included | ||||
Over-heating protection | / | Included | ||||
Power-off protection | / | Included | ||||
Over-current protection | / | Included | ||||
Overload protector | / | Included | ||||
Top Quality Buffer | / | Included | ||||
Country of Origin | China |
(The above picture is for reference to crane model only. Please refer to design drawing for quoted crane.)
The composition of the double girder gantry crane is basically the same as that of the overhead cranes, except that the main girders are supported by the legs. We offer different types of gantry cranes for you to choose from:
According to the trolley configuration, the cranes can be divided into single trolley and double trolley gantry crane.
The Other Gantry Crane cases in AustraliaWe are a crane manufacturer located in China, providing crane customization services to global crane customers. If you want to customize a gantry crane, you can leave a message on the website or Email: sales010@cranesdq.com, tell us the following information, and our sales manager will contact you:
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/) | Powered by Discuz! X3 |