Title: DDCSV4.1 serial communication [Print This Page] Author: alskvorcov Time: 2025-2-14 22:00 Title: DDCSV4.1 serial communication Last edited by alskvorcov In 2025-2-14 22:02 Editor
Hello all, this is my first post on this forum.
I just bought a DDCSV4.1 controller and would like to find some data how I can use the RS232 port. According to labels near the port, there should be two serial communication ports. I have read official manual several times but failed to find any small piece of information on how it can be used. Reading the Internet and this forum also did not give me any information. I could find some info how to use this port on DDCSExpert but looks like these controllers are not compatible.
Also I appreciate to get any advice where to find more information about DDCSV4.1 in addition to official manual. Looks like everybody discussing DDCSV3 and DDCSExpert but not DDCSV4.
Probably I posted this question in wrong branch of the forum but I did not find a branch devoted to DDCS4.1 controller
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)