Title: Can the DDSC v3.1 controller work with a lathe? [Print This Page] Author: alexdpol Time: 2020-10-12 15:04 Title: Can the DDSC v3.1 controller work with a lathe? Hello.
Bought a DDSC v3.1 controller for my lathe. Now there is the latest firmware (2020-03-06-112NOR).
I can't figure out how to do the thread, etc.
You may need to install a special firmware or configure it somehow, please help me figure it out.
Thank you in advance.Author: JessyChen Time: 2020-10-20 09:16
DDCS V3.1 cannot do the lathe job. Author: JessyChen Time: 2020-10-20 09:19
DDCS V3.1 cannot do the lathe job. DDCS-Expert can do, you can configure one axis to servo spindle, easy.Author: jorge1969 Time: 2020-10-24 05:25
Hi,can the ddSc v3.1 run a small plasma table
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)