Title: Enabled / Disabled - Driver [Print This Page] Author: Ricardo Time: 2020-9-9 03:39 Title: Enabled / Disabled - Driver How to send a command to the driver to activate before starting work and to activate after work?
You can use the pins, PIN 24 "XHOME", PIN 7 "YHOME" for other functions, as in the case of activating the stepper motor driver, that is, using the command "Enable / Power all stepper motors" and "M18: Disable all stepper motors "?
Thank you
RicardoAuthor: Ricardo Time: 2020-9-9 03:41
Sorry I missed informing my controller is DDCS V3.1
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)