Digital Dream Technology support

Title: DDCSV2.1 Stop when spindle turn on. [Print This Page]

Author: billydragon Time: 2018-5-5 04:23
Title: DDCSV2.1 Stop when spindle turn on.
Last edited by billydragon In 2018-5-5 05:45 Editor

I have install and config DDCSV2.1 for firsth time. Every thing seem oke. movement correct, Homing, limit working fine. I try run my g-code, without spindle on ( turn off inveter). My machine run from start to end. But problem is just start with spindle, Spindle turn on then machine star moving G0 and imediatly stop and RESET blinking. I can't find solution to solved this. Maybe some thing wrong in setting of Spindle control?

I used Inveter Best. connect VSO , GND and M3/M5 pin. I can set speed, turn on/off manual.

This is sort Video I take:
https://youtu.be/pL1oFkmAB-o

Author: Will_D Time: 2018-5-5 17:30
Again thanks for the new release but please tell what is new

Author: billydragon Time: 2018-5-5 23:13
I Found the problem.
I using limit sensor which using 3 wires. When Spindle work and step motor work it make noise then that limit sensor make electric switch like estop or limit signals.

Need to add noise filter or using just simple mechanic contact switching.

Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)