Digital Dream Technology support

Title: Slave axis [Print This Page]

Author: DBS Time: 2023-9-1 13:59
Title: Slave axis
Hello,

I read almost every information that I found, but can't understood:

I have Y gantry with 2 (two) Motors on it, BUT have "A" axis too.... So I must drive 5 motors.

Is this device SUPPORT SLAVE functionality like DDSCV 4.1 ????

Thank you in advance.

Denis

Author: DBS Time: 2023-9-12 02:40
Will someone answer?

Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)