Title: ddcs v4.1 slaving and z axis problems [Print This Page] Author: z300mrk Time: 2023-7-1 08:28 Title: ddcs v4.1 slaving and z axis problems One of the reasons I purchased the ddcs v4.1 controller for my workbee cnc because it supports slaving axis together. I have a double axis y gantry that i tried to slave y2 or (A) to y1. I followed the instructions from what i found online which states to
33. enable axis mapping function yes
34. master axis selection y axis
35. slave axis selection A axis
but only one side is moving. i don't know if i'm missing something in the settings and don't know what else to do. do you have any suggestions or where to find the answer to my problems would be much appreciated.
also my z axis is not moving at all. it shows the message ( z axis positive hard limit) so in the parameters i go to the z axis + limits and switch from low to high still nothing. What setting do i need to change to get the z axis working?
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)