Title: Using G02 and G03 [Print This Page] Author: Will_D Time: 2018-4-15 21:55 Title: Using G02 and G03 I have had a lot of problems trying to get these 2 codes to work properly.
I am in absolute metric mode:
G90 G94
G17
G21
and I have to use:
G90.1
before this code will work:
G1 X62 Y8.907
G1 Y2
G2 X58 Y-2 I-4
G1 X54.257
G2 X53.168 Y-1.677 J2
G3 X6.335 I-23.417 J-36.065
Note that I & J are relative arc centre coordinates BUT G90.1 means
"To go into absolute IJ mode, program G90.1. In absolute distance mode, IJK numbers represent absolute positions in terms of the currently active coordinate system."
Can someone please explain or is this an error in the software.
Any one else managed G02 and G03?
Author: Will_D Time: 2018-4-15 22:01
It took me a long to figure out the new security slider. Could you please use more English on the screens?Author: alexwalex Time: 2018-4-17 01:26
I think, that this controller not support G90.1 code. It support only standart ISO 6983-1 code.Author: Will_D Time: 2018-4-18 17:25
Oh yes it does recognise G90.1 and G91.1
Please change the G90.1 to G91.1 and run the code and see what happens.
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)