Title: Problem running some gcode [Print This Page] Author: ddcsv_user Time: 2020-2-22 00:36 Title: Problem running some gcode Last edited by ddcsv_user In 2020-2-22 00:41 Editor
Hi, new member hopefully you can help me with some "Teething" problems.
I have a DDSCV 2.1, I use Fusion 360 to generate my Gcode.
When I load this code on the DDSCV it does nothing, it flashes busy for a second and then reads ready.
A few pieces of code I generated have done the same thing or fired a syntax message at me.
Some code does work that I upload.
I have the post processor set as Fanuc.
Any help is greatly appreciated, included generated gcode.
Author: ddcsv_user Time: 2020-2-22 00:38 Last edited by ddcsv_user In 2020-2-22 00:40 Editor
Author: ddcsv_user Time: 2020-2-22 16:12
I read the post processor thread and turned helical moves off in the fanuc processor and removed o1001 and code worked.
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)
