Digital Dream Technology support

Title: Simple manual toolchange please [Print This Page]

Author: tonyho810 Time: 2019-11-25 03:41
Title: Simple manual toolchange please
Hi,
I have been trying for a long time to make a manual tool change. I just want to pause so I can put the new tool in the chuck then probe Z and continue. I am using fusion 360 and have tried posts from Brainright, Josef Poepsel and Faunc. The ddcsv ignores the toolchange.
I have tried making a t.nc with just M00 in it and also tried M5 G04P-1 but no luck.

Help me please.

Thanks

Tony

Author: tonyho810 Time: 2019-11-25 03:44
Hi again, I forgot to say I'm using the latest firmware 2019-10-26-112

Best regards,

Tony

Author: Will_D Time: 2019-11-27 18:38
Replied via MadModder!

Author: rodrigo Time: 2019-12-15 08:00
M110 QUANTO SONDAR O Z AINDA NÃO CONSEGUI

Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)