Title: DDCSV 3.1 v3 axis stopper working [Print This Page] Author: CronicPain Time: 2019-11-15 10:54 Title: DDCSV 3.1 v3 axis stopper working Last edited by CronicPain In 2019-11-15 10:56 Editor
Hey guys,
I bought a ddcsv 3.1 v3 only been two weeks, it's been working really good after a while my z axis stopped working
In the screen it shows jogging but nothing happens i changed motors and controllers but nothing, x and y are working properly
I used it with DM542
Thanks! Author: Will_D Time: 2019-11-15 18:17
Disconnect the stepper signals from the X or Y axis (known to work end to end) and connect to the Z stepper driver.
If Z now moves under the X or Y axis control then the problem is not in the DDCSV controller. Else it is!
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)