Title: Manual tool changing [Print This Page] Author: Frenchy Time: 2023-1-15 22:49 Title: Manual tool changing Hello everyone
I have a problem with the tool change. When I do a machining with different tool, the DDCS Expert controller does not stop the machine so that I can change the tool and adjust it. The machining continues with the same tool. I specify that I do not have ATC. I thank you in advance for your help
Author: Bubaraba Time: 2023-1-17 09:19
Попробуй указать номер инструмента в строке T1(T2...T3...) и поставить на паузу G04P-1, а потом меняй инструмент руками!
Пример:
S5000 M04
G00 X10 Y10 Z10
G01 X1 T1 Z1 F900
G00 Z50
T2(номер инструмента который требуется установить)
G04P-1(Программа встанет на паузу, шпиндель остановится, пока не сменишь инструмент, и не нажмешь на кнопку START).
Также надо будет указать в настройках(раздел инструмент) параметр(806 и 807), на какую высоту поднять шпиндель перед сменой инструмента по координате Z! Author: firukkk Time: 2023-11-13 04:38
Thank you very much for the information you provided, but there is something missing.
For example, the process was completed with tool number 1 and it was necessary to change the tool. We replaced it and installed the 2nd tool. It will be necessary to reset the Z axis with the probe. Does the system allow this?
*** My English may not be good. Sorry
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)
