Digital Dream Technology support

Title: Speed on auto mode [Print This Page]

Author: quizzotto Time: 2019-3-2 16:10
Title: Speed on auto mode
Hi,
i have a problem with the movement speed..
In the HOME mode everything is fine, the speed is the one set in the configuration file.
Instead, in the "goto 0" mode or in the work mode, the speed is locked as in the parameter "Speed of motor start running" (#33)
this happens either in "normal mode" or " g-code mode (#15)
of course the default operation speed (#76) is bigger than the (#33)

For example: if "Speed of motor start running" is set to 100 and on g-code i've a F1500 (and set #15 on g-code mode)
on the machine (ddcsv2.1) There is always "F 100 1500" ... and is soooo slowwww

any help?

thank

Author: edelec Time: 2019-3-4 23:46
What is Section 3 #80 set to? GOTO Zero runs at G0 speed maybe you have it set at 100
Richard

Author: quizzotto Time: 2019-3-5 00:02
Hi,
the G0 speed (#80) is set to 5000..

Max

Author: edelec Time: 2019-3-5 19:06
OK #77 #435 #436
Otherwise not sure. Can you adjust F whilst moving?
Richard

Author: quizzotto Time: 2019-3-6 16:00
So,  #77 is set to 5000, #435 and #436 both to 3000.
I can adjust  the F  only when are all stop..
Now I try to reinstall  the firmware and config all from the begin..

Author: ytliu Time: 2019-3-14 07:24
Can you provide your email address? I will send you a firmware version to see if I can solve your problem.

Author: quizzotto Time: 2019-3-27 16:09
Hi,
sorry for the delay..

my mail: s8-s8@hotmail.it

thank so much

Author: ytliu Time: 2019-3-27 17:41
Ok, I have already sent you an email.

Author: quizzotto Time: 2019-3-27 19:46
It works!
It's alive

Thank so much again!

Author: ytliu Time: 2019-3-27 20:26

Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)