Title: Probing does not work [Print This Page] Author: edelec Time: 2019-2-21 02:35 Title: Probing does not work I could not get probing to work so I installed 2019-01-22-106 but still not working.
My sensor is definitely pulling the probe input low when triggered.
I have enabled the probe in #68 with all options 1 2 and 3 but have no documentation to tell me what they are.
My code includes
G04P0;
M101
G91G01Z-100F10
M102
G04P0;
M103
G91 G0Z100F5
M102
G04P0;
but the Z -100 move does not stop when the probe is triggered.
Does anyone have any suggestions?
Richard
Author: JPoepsel Time: 2019-2-22 20:43
Hi!
Try to connect +12V-I to probe input when touching, not GND. This works for me!. (I tried out using a 1k Pullup for probe, inverting the input signal by the configuration but had no luck - which may be due to another error I had (my fault) - after detecting this error I did not try the pull up version anymore because I implemented the "normal" solution in between (also, since my spindle axis has no conducting connection to ground because of ceramic bearings...)
Josef
See also other postings concerning the problem posted by me in this forum. Author: edelec Time: 2019-2-22 22:36
Josef,
It sounds as if you have a V1.1 unit with Positive switching. I have a V2.1. I can understand that you would have had problems with the "touch tool to ground" type probes, the pull=up would have fixed it. I assume you now have a seperate unit with an internal switch. I am just touching probe input to ground to trigger with no response.Author: edelec Time: 2019-2-28 23:00
I have now discovered that Mode 3 runs defprobe.nc however that software does not react to the probe input terminal going low on this controller.
I have no idea what modes 1 and 2 do does anyone know?Author: Will_D Time: 2019-3-6 20:39
Have a read of this pdf:
Author: edelec Time: 2019-3-7 00:13
Thanks for that, interesting to see some documentation at last. However unfortunately it is of no help. The V2.1 controller I am running does not appear to respond to the probe input going low. I am somewhat p**d off.
Thanks again
RichardAuthor: Will_D Time: 2019-3-8 21:49
When creating that manual I was more concerned about the software side of things.
What value have you set #70 to?
What is your probe connected to (+12, ground or Probe)
What is your sensor plate connected to(+12 , ground or Probe)
Your sensor plate IS insulated from the machine table?
I can't think why they would change the probe interface on V2.1Author: edelec Time: 2019-3-11 00:38
Hi, Thanks for your interest.
#70 Low, Probe connect to Probe terminal, Sensor plate connected to GND-I, the unit is not even on a machine, bench testing by touching probe to plate and the negative Z move (after M101) does not stop. Checked other inputs typically all limits, and they work. Looks like the interrupt is not enabled for the probe input<G>.
The unit is being returned for a full refund and I do not want to see another one. Apart from this problem the support is less than minimal. I am going back to my LinuxCNC system even though it takes up more space than I really want.
Good Luck.
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)
