Title: Problem with input port (all) [Print This Page] Author: quizzotto Time: 2019-2-18 23:29 Title: Problem with input port (all) Hi,
I have a problem with my controller, I hope someone can help me.
The mpeg port and motor port works fine, but the input port they do not seem to work properly.
For example:
E-stop with low signal: it makes no difference if I press the button or not, nothing happens.
i try E-stop with high signal: pressing or releasing the button will play a beeep continuously..
hard limit (or home too) with low signal: same thing.. nothing when i press the switch.
hard limit with high signal: the axis don't move.. when i press the button or not..
i checked the voltage and there are 12 volt.. and of course the e-stop button and limit switch works fine (all 5)
maybe I lost something in the config file.. (i hope...)
i try a different firmware and do the same thing..
any suggestion ?
Thanks
Max Author: edelec Time: 2019-2-19 23:19
You do not say which version controller V1.1 or V2.1. The first has positive switching the second negative switching and I feel you are not wiring correctly. If you have V1.1 a normally open switch should be connected between 12v and the input. If you have V2.1 a normally open switch should be connected between GND and the input.
Please come back if this does not help.Author: quizzotto Time: 2019-2-20 00:18
edelec Posted at 2019-2-19 23:19
You do not say which version controller V1.1 or V2.1. The first has positive switching the second ne ...
Ok, you are my new hero now..
i have a v2.1..
I tried and it works.. (but my manual says to use 12 volts..)
thanks so much!Author: edelec Time: 2019-2-20 00:54
You are switching 12v in that the action of your switch closing allows current to flow from 12v through an opto-coupler through your switch to GND. Take a look at page 22 Fig 2-17. Author: Agranat Time: 2019-4-30 23:51
Hi. I have a same problem with V3.1.
Connecting GND to Estop - do nothing.
Need I connect it to +12V?Author: Agranat Time: 2019-5-1 00:36
well... I did it!
Need to connect 24v(19) -> COM+(20) and GND(37) -> COM-(1).Author: Ghost-51 Time: 2019-5-2 00:42 Last edited by Ghost-51 In 2019-5-2 02:03 Editor
Hi!!!
Help, I purchased a controller V3 .1, I can not get the work of induction sensors, they are not powered.
Also, external buttons and MPG do not work. Does anyone have a detailed power connection scheme. In the manual did not find.Author: ytliu Time: 2019-5-2 06:27 https://www.facebook.com/groups/ ... k/2801832963167190/
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)
