Title: Behaviour of home sensor togehter with endlimit [Print This Page] Author: DAMIGO Time: 2018-2-27 02:19 Title: Behaviour of home sensor togehter with endlimit Dear all,
I saw the DDCSV supports home sensors. Now I though I have end limit sensors on each axis.
I used:
x- Endlimit together with home x (set a wire brigde at the connector)
y- Endlimit together with home y (set a wire brigde at the connector)
z+ Endlimit together with home z (set a wire brigde at the connector)
Does the DDCSV support this? Or do I need to install separate homesensors?
Kind regards
Daniel
Author: ytliu Time: 2018-2-27 05:51
DDCSV2.1 support limit, home signal sharing. Connect the limit signal to the corresponding limit port (you do not need to connect to the home port at the same time) and then set the 116, 117, 118 parameters。
You can set them up like this：#116=2, #117=2, #118=1Author: DAMIGO Time: 2018-2-27 19:33
SUPER SUPER SUPER
That means at home run it does check for the home sensors before checking this homesensor as limit switch.
I have them already linked together with the corresponding Limit Switches. So will tests it.
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)
