Digital Dream Technology support

Title: Z axis raising [Print This Page]

Author: dannymeakins Time: 2022-8-23 21:14
Title: Z axis raising
Hi,

Can somebody from ddcnc please reply before I have to unwire my controller and set back up on my laptop?

My z axis is rising 0.02mm on each pass. Over a series of cuts on the same gcode it eventually becomes 6mm high. It can only be the controller as I have tested every other option.

What parameters can I change to fix this issue please?

Thanks

Author: Andrejg Time: 2022-8-31 02:22
Hello are you using hard or soft algorithm ?

Author: geraldo.com Time: 2022-9-1 01:52
estou com o mesmo problema se alguem poder me ajuda

Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)