Digital Dream Technology support

Title: Error "Could not find subprogram" [Print This Page]

Author: Frans Time: 2022-8-1 20:21
Title: Error "Could not find subprogram"
In the program below I get the error message that the Subprogram is not found. Can someone tell me what is wrong with this.
( Made by Frans Berkers)
( Untitled 6/20/2022 9:35:54 PM )
( T0 : 3.0 )

#100=0 (uitgang niveau en daarna cum diepte)
#200=0.2 (boor diepgang per keer *** AANPASSEN ***)
#300=3.25 (totale diepte ************ AANPASSEN ***)
#400=17 (AANTAL KEREN VAN UITVOEREN)
#500= 100 (snelheid van boren)

G21 G90 G64 G40
S2500M3
G0 X0 Y0 Z3 (T0 : 3.0)
F#500
(M68) (start motor spindel in DDCS)
M4 P1000
M98 P11 L17
M30
(M69) (stop spindel motor in DDCS)
M5

O11
#100 = #100-#200
G1 Z#100
G0 Z3
M4 P500
M99

with kind regards, Frans

Author: hendrix Time: 2023-8-14 20:26
Did you ever solve this problem?

Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)