Title: G-code is not executed. [Print This Page] Author: NikoTien Time: 2019-1-30 13:25 Title: G-code is not executed. Hello,
I assembled a homemade milling machine, trying to launch the g-code, brings the machine to the reset state, in manual mode, the mill can move on all 3 axes without noticeable problems.
About the machine, I used a combination of HBS860H (driver) + 86HBS85-120 (hybrid servo motor),
machine control takes place through DDCSV 2.1 with the latest firmware.
If anyone encountered a similar problem, I will be glad to any advice. Author: JPoepsel Time: 2019-1-30 16:21
May be, there is a syntax error in your G-Code. If you post it here, we can have a look.
You mentioned, that you can move the spindle in MPG mode, so I assume, the end switches are configured correct and do not stop the movement. But you should double check this also!Author: NikoTien Time: 2019-1-31 11:32
Thanks for the quick reply, immediately after your message I checked the Hardware limits, looks fine, then simply deactivate them, the machine executed the G-code without any errors. apparently, something was wrong in the parameters.
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)