Title: edge and thickness sensor [Print This Page] Author: mirek151 Time: 2019-1-23 05:48 Title: edge and thickness sensor Last edited by mirek151 In 2019-1-23 06:41 Editor
Is it possible to make in ddcsv such a sensor as it is on the following movie ?
Edge and tickness sensor similar movie Author: edelec Time: 2019-1-23 17:18
I would have thought that you should take a look at the probe software in slib.nc and consider writing something similar. Not sure how well the probe input switches in this sort of setup but that can be helped with some additional electronics.
RichardAuthor: mirek151 Time: 2019-1-23 20:12
Thank you on the forum I found a probe solution, as well as updates to my ddcsv2.1. It is described in the link
I am thinking about translating it into Polish.
Thank you again.
Welcome Digital Dream Technology support (http://bbs.ddcnc.com/)